2001 Dodge Ram Van 2500 2WD

VEHICLE DESCRIPTION: QUAD CAB PICKUP TRUCKS. THE UPPER CONTROL ARMS ATTACHED WITH CADMIUM COATED NUTS CAN CAUSE THE BOLTS TO STRETCH DUE TO THE APPLICATION OF A HIGHER THAN SPECIFIED CLAMP LOAD. BREAKAGE OF THE UPPER CONTROL ARM FASTENERS COULD CAUSE THE AXLE TO ROTATE FORWARD UNDER BRAKING CONDITIONS.

VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES, PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." SOME OF THE OWNER'S MANUALS FOR THESE VEHICLES ARE MISSING INSTRUCTIONS THAT PROVIDE A STEP-BY-STEP PROCEDURE, INCLUDING DIAGRAMS, FOR PROPERLY ATTACHING A CHILD RESTRAINT SYSTEM'S TETHER STRAP TO THE TETHER ANCHORAG

VEHICLE DESCRIPTION: VANS. A SUBSTITUTE WHEEL LUG NUT TIGHTENING PROCESS MAY NOT HAVE BEEN SUFFICIENT TO ASSURE PROPER TORQUE OF THE LUG NUTS.

VEHICLE DESCRIPTION: CERTAIN 2500 WAGONS WERE EQUIPPED WITH INCORRECT LOAD RANGE TIRES.

VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALB

VEHICLE DESCRIPTION: VANS AND WAGONS NOT EQUIPPED WITH POWER FRONT SEATS. IN THE PRESENCE OF ROAD SALT, WATER, AND POSSIBLY OTHER DEBRIS, THE POWER SEAT CONNECTOR LOCATED BENEATH THE DRIVER'S SEAT COULD DEVELOP A HIGH RESISTIVE SHORT CIRCUIT THAT CYCLES THE CIRCUIT BREAKER.

VEHICLE DESCRIPTION: QUAD CAB PICKUP TRUCKS EQUIPPED WITH A CAMPER PACKAGE AND OVERLOAD SPRINGS. THE REAR AXLE SPACER PLATE COULD LEAD TO DEFORMATION OF THE UPPER SPRING PLATE DURING ASSEMBLY OF THE AXLE TO THE VEHICLE RESULTING A SOFT JOINT.

ON CERTAIN PICKUP TRUCKS, THE ALTERNATOR WIRE CONNECTION TO THE POWER DISTRIBUTION CENTER (PDC) CAN LOOSEN.

ON CERTAIN VAN AND WAGON VEHICLES EQUIPPED WITH 4-WHEEL ANTILOCK BRAKE SYSTEMS (ABS), AFTERMARKET BATTERIES MAY LEAK ELECTROLYTE ONTO THE ABS CONTROL MODULE CONNECTOR, WHICH CAN COMPROMISE SEALING INTEGRITY OF THE CONNECTOR.

CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

ON CERTAIN VAN AND PICKUP TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS, THE IGNITION/PARK SHIFT INTERLOCK SYSTEM MAY BECOME INOPERATIVE. THIS CAN ALLOW THE SHIFTER TO BE MOVED OUT OF THE "PARK" POSITION WITH THE IGNITION KEY REMOVED (OR IN THE "LOCK" POSITION). THIS CAN ALSO ALLOW THE IGNITION KEY TO BE REMOVED WHEN THE SHIFTER HAS NOT BEEN PLACED IN THE "PARK" POSITION.

CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY.

K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.