1999 Dodge Ram 1500 Pickup 2WD

VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH GASOLINE ENGINES AND MANUAL TRANSMISSIONS. THE UNDERBODY HYDRAULIC CLUTCH LINE HEAT SHIELD IS TOO SHORT, ALLOWING THE PLASTIC CLUTCH LINE MATERIAL TO BE DIRECTLY EXPOSED TO EXHAUST TEMPERATURES. IT IS POSSIBLE TO EXCEED THE MELTING TEMPERATURE OF THE CLUTCH LINE MATERIAL.

VEHICLE DESCRIPTION: PASSENGER VANS AND WAGONS EQUIPPED WITH COMPRESSED NATURAL GAS (CNG). THE FUEL HOSE THAT CONNECTS THE LEFT AND RIGHT FUEL RAILS MAY SHRINK AND LEAK FUEL IF EXPOSED TO HIGH ENGINE OPERATING TEMPERATURES.

VEHICLE DESCRIPTION: VANS EQUIPPED WITH COMPRESSED NATURAL GAS (CNG) FUEL TANKS. INCORRECT FUEL TANK STRAPS WERE INSTALLED ON THE SMALL FUEL TANK. AS A RESULT, THE FUEL TANK MAY NOT BE SECURELY ATTACHED TO THE VEHICLE.

VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH MANUAL TRANSMISSION, V10 ENGINES AND FOUR-WHEEL-DRIVE TRANSFER CASES. UNDER SUSTAINED MAXIMUM RATED VEHICLE LOAD, WHILE DRIVING UP A STEEP GRADE IN FOUR-WHEEL-DRIVE LOW RANGE IN HOT AMBIENT CONDITIONS, THE LOCAL EXHAUST TEMPERATURE PROXIMATE TO THE HYDRAULIC CLUTCH LINE CAN GENERATE LINE TEMPERATURES THAT EXCEED THE TEMPERATURE LIMIT OF THE CLUTC

VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH OPTIONAL TRAILER HITCH. THE TRAILER HITCH SIDE BRACKETS WERE MANUFACTURED USING MATERIAL WITH INSUFFICIENT STRENGTH.

ON CERTAIN PICKUP TRUCKS ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING "SALT BELT" STATES: MAINE, NEW HAMPSHIRE, VERMONT, MASSACHUSETTS, RHODE ISLAND, CONNECTICUT, NEW YORK, NEW JERSEY, PENNSYLVANIA, DELAWARE, MARYLAND, THE DISTRICT OF COLUMBIA, WEST VIRGINIA, OHIO, INDIANA, MICHIGAN, ILLINOIS, WISCONSIN, MINNESOTA, IOWA, AND MISSOURI. CORROSION OF THE RETURN SPRING ON THE HOOD S

VEHICLE DESCRIPTION: CERTAIN VAN, WAGON, PICKUP TRUCKS, PASSENGER AND SPORT UTILITY VEHICLES, FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE FRONT SEAT BELT RETRACTOR MAY NOT COMPLY WITH THE REQUIREMENTS OF THE STANDARD.

VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALB

ON CERTAIN VAN AND WAGON VEHICLES EQUIPPED WITH 4-WHEEL ANTILOCK BRAKE SYSTEMS (ABS), AFTERMARKET BATTERIES MAY LEAK ELECTROLYTE ONTO THE ABS CONTROL MODULE CONNECTOR, WHICH CAN COMPROMISE SEALING INTEGRITY OF THE CONNECTOR.

CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAI

K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.