1997 Chevrolet Blazer 4WD

VEHICLE DESCRIPTION: EXTENDED CAB PICKUP TRUCKS EQUIPPED WITH 60/40 FRONT BENCH SEATS AND EXTENDED CAB PICKUP TRUCKS AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH MANUAL LOCKING RECLINER BUCKET SEATS. THE OUTBOARD SAFETY BELT WEBBING ON THE DRIVER'S AND/OR PASSENGER'S SEAT CAN SEPARATE DURING A FRONTAL IMPACT.

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1996-1997 4-WHEEL DRIVE CHEVROLET BLAZER, GMC JIMMY, AND OLDSMOBILE BRAVADA SPORT UTILITY VEHICLES. SOME OWNERS HAVE HAD TO PAY FOR REPLACEMENT OF THE UPPER BALL JOINTS THAT HAVE SEPARATED. GM IS PROVIDING A SPECIAL POLICY TO THESE OWNERS TO C

ON CERTAIN SPORT UTILITY VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, AND WISCONSIN, AND IN THE DISTRICT OF COLUMBIA. FAILURE OF AN UPPER CONTROL ARM BALL JOINT ASSEMBL

CERTAIN SPORT UTILITY VEHICLES WERE BUILT WITH A DRIVER'S SEAT BELT BUCKLE ASSEMBLY THAT CONTAINS AN ENERGY-ABSORBING LOOP. SUSTAINED LOADS OF SUFFICIENT MAGNITUDE AND DURATION ON THE BELT IN SEVERE CRASHES COULD FULLY DEPLOY THE BUCKLE ENERGY-ABSORBING LOOP, INTRODUCING A TOTAL OF 10 ADDITIONAL INCHES OF WEBBING INTO THE SEAT BELT SYSTEM. THE FREE FALLING LATCH PLATE USED IN THIS SYSTEM MAY ALL

CERTAIN SPORT UTILITY VEHICLES, MINI VANS, AND PICKUP TRUCKS MAY DEVELOP A SHORT CIRCUIT IN THE ELECTRIC OUTSIDE REARVIEW MIRROR SWITCH.

CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.